- -40%
My cart:
0
Your cart is currently empty.
Segments 4 - 9x9.8x1.8cm - Opening: 2.5cm - Fusing Mould
958.SS001
7953
Creative Ceramics Moulds for Fusing, Slumping & Casting
With this mould you can make casting samples from frit, crushed glass or other small components without having to cast a refractory mould beforehand. The smooth inside of the mould will give you a shiny surface on the finished piece. Also ideal from prefabricating components from frit etc. to be further used in fused or cast work.
The recommended firing chart will lead to a smooth piece of glass with a glossy surface. The finished piece will shrink somewhat, depending on the amount of glass used. Some coldworking on the edges with a diamond pad may be necessary.
By lowering the temperature to a sinter firing (approx. 720°C) the piece will shrink less and have a rougher ‘Sugary’ look similar to pâte-de-verre.
By lowering the temperature to a sinter firing (approx. 720°C) the piece will shrink less and have a rougher ‘Sugary’ look similar to pâte-de-verre.
Recommended Firing Chart
Please Read: This firing recommendation has been calculated for use with Bullseye glass. Whereas the most typical casting glasses are frit and billets, you can have great results using sheet glass, stringers, rods as well as prefabricated components. The chart shown below is also based on the assumption that you are using a top fired kiln, e.g. Paragon GL22, GL24, BVD Flat bed kilns etc.
Data sheet
- Creative Ceramics Mega Sale
- Category A
Specific References
7953 0.180000
